|
 |
Approx
time req'd
 |
|
|
| |
|
 |
• Match
shoe size to hoof. |
| |
|
|
 |
• Place shoe in container on shoe
support.
• Add Imprint Hoof Repair material if required.
• Add boiling water... 100°C to cover rim only.
• Heat until malleable – approx 2 minutes. |
| |
|
|
| |
 |
• Whilst shoe is heating, bevel
edge of hoof wall.
• Create 6-8 crisp keying points around the
lower edge
of hoof wall.
• 8 or 10mm diameter and 2/3 depth of hoof wall. |
| |
| |
 |
• Apply Imprint Adhesive to hoof
wall to height of
shoe rim. |
| |
|
| |
|
 |
• Remove shoe from container
wearing wet latex gloves.
• Shake off excess water.
• If required, add extra Imprint Hoof Repair to
frog
plate to ensure ample contact
with frog.
• Run a wet finger around rim to open out a
little. |
| |
| |
| |
 |
• Position
and mould shoe centrally on foot.
• Quickly blend rim to hoof wall.
• Maintain original rim height.
• Press plastic into indentations.
• Ensure good frog contact.
• Blend heels of shoe to hoof. |
| |
| |
| |
 |
• Harden
with Imprint Freezer.
• The shoe should be hard before weight-bearing. |
| |
| |
|
 |
• Run a
bead of Adhesive around rim.
• Fitting is complete.
• Let horse stand until adhesive is hard.
• Minor finishing can be done with a rasp to
smooth
edges.
• Any area needing remodelling can be reheated
using a
small flame torch.
|
| |
| |
| |
| |
• Shoe
Removal – rasp off rim and peel away from heels.
|
| |
|
| |
|
